|
ADC:
|
YES |
|
Architecture:
|
8-bit |
|
CAN interface:
|
NO |
|
Case:
|
SOP08W |
|
DAC:
|
NO |
|
EEPROM memory:
|
64B |
|
Encryption:
|
NO |
|
ETHERNET interface:
|
NO |
|
FLASH memory:
|
1kB |
|
Frequency:
|
20,000MHz |
|
Manufacturer:
|
MICROCHIP |
|
Number of I/O:
|
6 |
|
Operating temperature (range):
|
-40°C ~ 85°C |
|
RAM memory:
|
64B |
|
SPI interface:
|
NO |
|
Supply voltage range:
|
1,8V~5,5V |
|
TWI (I2C) interface:
|
NO |
|
UART/USART interface:
|
NO |
|
USB interface:
|
NO |
Detailed description
Manufacturer: ATMEL
Family: Embedded – Microcontrollers
Series: AVR® Attiny
Core Processor: AVR
Core Size: 8-Bit
Speed: 20MHz
Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
Number of inputs/outputs: 6
Program Memory Size: 1KB (512 x 16)
Program Memory Type: FLASH
EEPROM Size: 64 x 8
RAM Size: 64 x 8
Operating voltage: 1.8 V ~ 5.5 V
Oscillator Type: Internal
Operating Temperature: -40°C ~ 85°C
Case: SO8-W
The AVR core combines a rich instruction set with 32 general purpose working registers. All 32 registers are directly connected to the Arithmetic Logic Unit (ALU), allowing two independent registers to be accessed in one single instruction executed in one clock cycle. The resulting architecture is more code efficient while achieving throughputs up to ten times faster than conventional CISC microcontrollers.
The ATtiny13A provides the following features: 1K byte of In-System Programmable Flash, 64 bytes EEPROM, 64 bytes SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit Timer/Counter with compare modes, Internal and External Interrupts, a 4-channel, 10-bit ADC, a programmable Watchdog Timer with internal Oscillator, and three software selectable power saving modes. The Idle mode stops the CPU while allowing the SRAM, Timer/Counter, ADC, Analog Comparator, and Interrupt system to continue functioning. The Power-down mode saves the register contents, disabling all chip functions until the next Interrupt or Hardware Reset. The ADC Noise Reduction mode stops the CPU and all I/O modules except ADC, to minimize switching noise during ADC conversions.
The device is manufactured using Atmel’s high density non-volatile memory technology. The On-chip ISP Flash allows the Program memory to be re-programmed In-System through an SPI serial interface, by a conventional non-volatile memory programmer or by an On-chip boot code running on the AVR core.
The ATtiny13A AVR is supported with a full suite of program and system development tools including: C Compilers, Macro
Assemblers, Program Debugger/Simulators, and Evaluation kits.
